Re: [NMusers] NonMem and EVID=2

From: Jeroen Elassaiss-Schaap (PD-value B.V.) <"Jeroen>
Date: Tue, 23 Apr 2019 21:15:52 +0200

Hi Johan,

If you could share your code and a relevant snippet of your dataset you
might get more specific help. Without such detail: Bill's suggestion
(time-varying covariate) could extend to the covariance step as well -
those calculations might be more sensitive to the different values
generated (values may be much smaller or larger because they depend on
individual eta's). If you use differential equations, the additional
time steps requested by EVID=2 might be more sensitive in a similar way.

BTW, with nm7.3 onwards there is a system to prevent EVID=2 calculations
in the est/cov steps, by using MDV=101 or larger. In intro nm7 guide I66:

"I.66 Ignoring Non-Impact Records During Estimation (NM73)
Typically users may produce data files that are augmented with
additional non-dose, non-
observation records in order to output predicted values at additional
times to create high
resolution curves. However, too many of such records tend to slow down
the estimation
analysis. As of NM73, if an MDV is set to a value greater than or equal
to 100, it is converted to
that value minus 100 upon input, but will not be used during estimation
or covariance
assessment, only for table outputting. This option allows you to use the
same file for estimation
and table outputs, without significantly slowing down the estimation. So
if MDV=101, it will be
converted to 1 upon use for final evaluations, and the records will be
ignored during estimation."

Hope this helps & best regards,

+31 6 23118438
-- More value out of your data!

On 23/4/19 5:33 pm, Johan Rosenborg wrote:
> Hello everybody,
> In order to obtain predicted values in a PopPK analysis without
> covariates at points in time with no actual values I have inserted
> extra rows indicated with EVID=2. The covariance step is completed
> when including these extra rows and precision of the parameter
> estimates are adequate. When omitting the extra rows
> {IGNORE=(EVID.EQ.2)}, I get exactly the same parameter estimates, the
> covariace step can be completed with some difficulty, but precision of
> the parameter estimates are now inadequate. I use METHOD=1 and just
> like Ahmed Abbas Suleiman experienced
> ( 2
> <>), my
> outcome did not differ between the two conditions when setting
> METHOD=0. I saw that William Denney has responded to a similar
> question in 2016
> ( 2
> <>).
> I cannot see any response to Ahmed’s comment; do you Bill or somebody
> else have any idea why the outcomes differ with METHOD=1 but not with
> METHOD=0 in NonMem when including extra rows in the data set?
> Thank you in advance and kind regards,
> Johan

Received on Tue Apr 23 2019 - 15:15:52 EDT

This archive was generated by hypermail 2.3.0 : Fri Sep 27 2019 - 17:04:35 EDT